CTM 360 HS

The CTM 360 HS Series Label Applicator is a rugged, versatile applicator loaded with standard features that are optional on most other applicators. The 360 HS Series Applicator can be configured as a blow on, merge or tamp applicator. Each module can also be easily switched from right to left hand dispensing mode. Each applicator is equipped with a 20" non-powered rewind.

 • 2100 Inches Per Minute Web Speed
 • Longer Run Time Between Roll Changes
 • Stepper Motor Drive
 • 5" Label Width
 • Right Hand or Left Hand Conversion Capabilities
 • Intelligent Control Equipped with Onboard I/0
 • Interchangeable Merge, Tamp or Air Blow Modules
 • Dual Microprocessors

Stepper Motor
The 360 HS is equipped with state-of-the-art electronics featuring Dual Microprocessor control. One 32-Bit processor supervises the motion loop resulting in faster response times and improved application accuracy. The 360 HS controller is also equipped with onboard I/0 prewired to external connectors to accommodate the following:
 • Low Label Conditions
 • Web Break Conditions
 • Tamp Extend and Tamp Home Switching
 • Rate and Velocity Compensation
 • Profiling
 • Zero Downtime Configuration of Applicators

Each machine is shipped preprogrammed with prewired connectors to control all of the above accessories. Some additional hardware may be required.

The electronic control assembly has been packaged as a module. Each control module can be easily removed for repair or replacement, eliminating costly downtime and servicing costs.